Western Telematic PollCat III Betriebsanweisung PDF herunterladen (Seite 74)

R A F F I C

N A L Y S T

D M I N I S T R A T I V E

U I D E

U N E

20 11 I

M P A C T

E C H N O L O G I E S

N C

O N F I D E N T I A L A N D

R O P R I E T A R Y

3.1.3 Ports

Serial ports need to be setup on the Traffic Analyst server's PC so that Traffic Analyst can

communicate with the switches. This step can be skipped if all of your switches will be

communicating via TCP/IP (Hicom 300 v. 6.6, HiPath 3000, HiPath 4000, OpenScape

Voice, Cisco & Nortel switches only).

Go to the System Menu and select the Ports option. The following window displays:

To define a serial port, do the following:

Select Add.

In the dialog window that pops up, enter a Name and Number of the port (e.g. COM1 is

the name, and 1 is the number). Select OK.

Enter the Interface – Direct RS232, Modem or DCM/DCI. (DCM/DCI is only available in

Siemens environments).

Provide a Maximum Baudrate for the port. This can be greater than, but not less than, the

switch baud rate.

Select Apply if other ports need to be defined or OK to accept your changes and close the

Ports window. We recommend that ports defined here should only be used for Traffic

Analyst.

3.1.4 Modem Pools

Modem pools are optional, and they are only recommended if more than one modem is

used and is polling many switches. A modem pool optimizes the use of the modems

available for polling, so that the first available modem in the pool can perform the next poll.

Go to the System Menu and select Modem Pools. The following window displays:

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 173 174

Keine Kommentare

Western Telematic PollCat III Betriebsanweisung Seite 74