Western Telematic PollCat III Betriebsanweisung PDF herunterladen (Seite 11)

3. Hardware Installation

This section describes the hardware installation procedure, which consists of the steps listed

below. For more information, please refer to the corresponding section for each step.

1. Use the Set-Up Switches to select default communication parameters and PollCat III

options.

2. Connect the Data Cables and telephone line.

3. Connect the AC Power Cable to the PollCat III unit.

3.1. Set-Up Switches

The Set-Up Switches are used to select default communication parameters and enable options

such as the Direct Connect Mode, Computer Port Password, and Power Up Default.

3.1.1. Default Baud Rate for Computer Port (Sw1, Sw2, Sw3)

Set-Up Switches One, Two, and Three select the default Baud Rate for the Computer Port.

After the PollCat III is installed, Command ^B91 can also be used to redefine the Computer

Port Baud Rate.

Baud Switch 1 Switch 2 Switch 3

9600 * Down Down Down

38.4 K Up Down Down

19.2 K Down Up Down

4800 Up Up Down

2400 Down Down Up

1200 Up Down Up

600 Down Up Up

300 Up Up Up

* = Factory Setting

3-1

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 146 147

Keine Kommentare

Western Telematic PollCat III Betriebsanweisung Seite 11