Western Telematic PollCat III Betriebsanweisung PDF herunterladen (Seite 150)

14-4

PollCat NetLink II - User’s Guide

14.3. Configuring NetLink II with

Saved Parameters

Once parameters have been saved to an ASCII ﬁle, the ﬁle can then be

uploaded to the NetLink II to reconﬁgure the unit without manually

deﬁning each parameter.

The ASCII ﬁle with the saved parameters can also be uploaded to other

NetLink II units. This allows rapid set-up when a number of units will be

conﬁgured with the same parameters.

1. Access command mode as described in Section 17.1.

a) If the password function is enabled, enter the valid Administrator

Level password. NetLink II must be operating in Administrator

Mode in order for this procedure to function.

b) Note that this procedure can be performed from anywhere in the

NetLink II menu system.

2. Use your communication program's (e.g., Tera Term's) upload function

to transfer the ﬁle that contains the saved parameters to the NetLink II

unit via modem or the Console Port.

a) Select ASCII File Format.

b) Specify the ﬁlename and directory location for the ﬁle with the

saved parameters. Note that it is very important to enter the

correct ﬁlename and location. Sending an incorrect ﬁle to the

NetLink II unit will cause unpredictable results.

3. If an Error message is received at any time during the parameter

upload, repeat steps 1 and 2 above to resend the entire ﬁle.

Notes:

• If the ﬁle with the saved parameters is sent to NetLink II via

the Computer Port (from a local PC), changes will take effect

immediately.

• If the parameter ﬁle is sent to NetLink II via the Modem Port,

Modem Communication Parameters will not take effect until

after you exit from Command Mode. The Port Status Screen will

not show the new Modem Port parameters until you have exited

and re-entered Command Mode.

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 237 238

Keine Kommentare

Western Telematic PollCat III Betriebsanweisung Seite 150