Western Telematic PollCat III Betriebsanweisung PDF herunterladen (Seite 21)

4-1

4. Hardware Installation

The hardware installation procedure includes the following steps:

1. Connect the VIP unit to an appropriate power supply

(see Section 4.1).

2. Use the Set-Up Switches to select default communication parameters

and options (see Section 4.2).

3. Reset the VIP unit and clear the ﬂash memory (see Section 4.3).

4. Connect the data cables, network cable and telephone line

(see Section 4.4)

4.1. Connect the VIP to Power Supply

Notes:

•

When Switch 8 is UP (enable Power Up Default) and there is a

power interruption, baud rates will return to the default values

selected by Set-Up Switches 1 through 5.

•

After conﬁguring the unit with menu selected parameters, you

may wish to return Set-Up Switch 8 to the DOWN position. This

will cause the VIP to use menu selected parameters whenever the

unit is powered off and on.

CAUTION: This device should only be operated with the type of

power source indicated on the instrument nameplate. If you are

not sure of the type of power service available, please contact

your local power company.

4.1.1. AC Powered Units

Plug the power cable into the receptacle on the VIP back panel. The VIP

features a self-adjusting power supply that automatically adapts for 115 or

230 VAC. Place the AC Power Switch in the ON position to apply power,

the ON indicator will light and the RDY indicator will ﬂash.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 265 266

Keine Kommentare

Western Telematic PollCat III Betriebsanweisung Seite 21