Western Telematic CMS-16 Bedienungsanleitung PDF herunterladen (Seite 16)

Up Down XON/XOFF

Down Up Both

Up Up None

* = Factory Setting

4.2.3. Default Response Message Format (Sw6)

When commands are invoked, the CMS can respond with either verbose (English text) or terse

(numeric / abbreviated) messages. Response messages are summarized in Section 10.2. After

installation, the /P command can also set the response format to "none" (Quiet Mode). When

Quiet Mode is selected, the unit will not send response messages.

Switch 6 Default Response Message Type

Down Verbose (English Text) *

Up Terse (abbreviated / numeric)

* = Factory Setting

4.2.4. Default Command Echo (Sw7)

Switch Seven enables or disables the Command Echo. When enabled, characters sent to the

CMS will be echoed back to the control device.

Switch 7 Default Command Echo

Down Enable*

Up Disable

* = Factory Setting

4.3. Initialize Unit to Default Settings

If Option Switch settings are changed, new parameters will not take effect until the CMS is

initialized.

Caution: After initialization, the CMS will revert to the parameters specified

by the Option Switches. Any command-selected parameters will be lost.

Simultaneously press the SET and CLEAR buttons, located on the face of the CMS.1.

Release the CLEAR button, wait for the Port LEDs to flash, and then release the SET

button.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 61 62

Keine Kommentare

Western Telematic CMS-16 Bedienungsanleitung Seite 16